- +36 30 411 3455
- info@humanex-tech.com
Removal of chemical deposits, paint, tar (gudron) and process contamination from surfaces using a dry, non-corrosive technology. Plant staff never have to touch the hazardous materials — and neither the surface nor the geometry is damaged.
We remove the chemicals deposited on equipment and structures — properly prepared, in appropriate protective gear. Plant staff never have to touch the chemicals: the plant operates more safely.
On a clean pump foundation, any drip or leak is visible immediately — the fault can be detected before it causes major damage. Cleanliness is also a basic requirement of the lean (5S) approach.
Aluminium insulation cladding is expensive — replacing it means significant material and labour costs. Dry cleaning restores the existing cladding to reusable condition without soaking the insulation.
Removal of paint, tar (gudron) and old coatings from metal surfaces — even during operation. The surface is prepared for the new coating without damaging the base material.
Plant staff never touch the deposited hazardous material — only our team does, in appropriate protective gear and trained for the task.
The abrasive media we use does not damage bearings or rotating equipment — which is why cleaning can be carried out during operation.
We sweep up or wash away the residual dust — the area is returned to the plant tidy and clean.
With the right combination of pressure and abrasive media, only the contamination is removed — the base metal is not damaged, and there is no wet, corrosive after-work.
On-site inspection: type of deposit, surface material, access and HSE requirements are agreed.
We remove the deposits with biodegradable, non-corrosive abrasive media — even during operation, without harming the surface.
We sweep up or wash away the residual dust — no contamination is left in the area.
The surface is returned ready for coating or operation, and the area is handed back to the plant in good order.
BeforeAfter
BeforeAfter
Yes. The abrasive media we use does not damage bearings or rotating equipment, so cleaning — paint removal, for example — can be carried out safely during operation. In explosive atmospheres we work with ATEX-certified equipment.
Because only our team comes into contact with the deposited chemicals — in appropriate protective gear, prepared for the task. Plant staff never have to touch the hazardous materials, so the exposure risk is reduced.
No. We adjust the combination of pressure and abrasive media to the surface: only the deposit is removed, while the base metal and the geometry remain untouched. The surface is handed over ready to receive a new coating.
Practically nothing: we sweep up or wash away the residual dust. The abrasive media is biodegradable and non-corrosive, so no hazardous waste is generated.
Aluminium insulation cladding is a costly item in both material and labour. Dry cleaning restores the existing cladding to reusable condition — at a fraction of the cost, and the mineral wool insulation does not get soaked either.
Because on a clean foundation, any drip or leak is visible immediately — the fault can be detected and addressed early. A tidy, clean plant environment is also the basis of lean (5S) operation.
Tell us what material and surface you are dealing with — we will propose a dry cleaning solution.
Tell us what you're working with — our engineers will propose the right solution.