Why do finned-tube air coolers foul up?
The finned tubes of industrial air coolers (fin-fan heat exchangers) are in contact with ambient air across an enormous surface area. The air drawn through by the fans carries pollen, dust, airborne seeds, insects and oily, dirty deposits into the fin gaps, and where wet cooling assistance is used, scale also precipitates on the fins. The gaps between the fins gradually clog, airflow and heat transfer deteriorate — and cooling capacity typically declines unnoticed, year after year.
What does a fouled air cooler cost you?
A clogged finned-tube bundle means higher outlet temperatures, capacity restrictions in summer, higher fan energy consumption and shorter equipment life. In refineries, chemical plants and power stations the air cooler is often the bottleneck of the whole process: a few degrees of extra cooling can directly prevent production losses. The operators of one returning client measured a 300% increase in cooling capacity after our most recent cleaning — it must be said, this was an exceptional result, measured on an extremely fouled air cooler. The average improvement is smaller, but the before-and-after measurements demonstrate it clearly in every single case.
Air cooler cleaning during operation: how is it possible?
Conventional high-pressure water washing typically requires a shutdown, electrical isolation and sheeting off the surroundings — and the high pressure easily bends back and damages the soft aluminium fins. Chemical (active foam) cleaning can likewise only be carried out on shut-down, de-energised equipment: the foam has to be applied, left to act and then rinsed off, the chemical run-off has to be collected and treated — and chemical residue left between the fins can cause corrosion over time. NPJ dry cleaning, by contrast, works dry, without water or chemicals, which is why the air cooler can be cleaned during operation, without a shutdown:
- Damage-free: professional cleaning does not bend the fins and the tubes are not damaged;
- No shutdown: in most cases the technology can be applied while the unit is running, with the fans stopped;
- No wastewater: no chemical run-off, no need to sheet off the surroundings;
- Measurable results: every cleaning is closed out with a measurement report.
Scale on the finned tubes: what can be done?
With wet cooling assistance (water spraying), a hard layer of scale can build up on the fins even when softened water is used, degrading both airflow and heat transfer. Scale removal from the finned tubes calls for a special, fin-friendly procedure — instead of aggressive acid treatment or high-pressure washing, a technology that does not weaken the aluminium fins. We cover this in detail on our air cooler cleaning during operation service page.
When is it worth having your coolers cleaned?
In our experience one cleaning per year is sufficient at most plants, ideally before the summer peak load (in spring); in pollen-intensive environments (poplar trees, agricultural areas) even twice a year. Telltale signs are rising outlet medium temperatures in summer and fans running continuously at maximum speed. Read more: Why is your industrial air cooler losing performance?
Frequently asked questions
Do we really not have to shut down the plant for the cleaning?
No. NPJ dry cleaning can be carried out on running equipment, during operation — one of the most important advantages of this technology over other cleaning methods.
Won’t the fins get damaged?
No: the procedure was developed specifically to protect the soft aluminium fins, and across our references we have worked without a single case of fin damage.
Which air coolers is the procedure suitable for?
Every finned-tube design: horizontal and vertical air coolers, fin-fan heat exchangers and condensers — in refineries, chemical plants, gas storage facilities and power stations alike.
How do I know it was worth it?
We hand over every job with a measurement report: the airflow readings taken before and after the cleaning show the improvement in black and white.
Request a quote: get in touch with us — we work EU-wide with VCA/SCC** certification, cleaning ~7,000 m² of air cooler surface a year.